K-TEK KPCK16 Coiled Cabled Kit for The Mighty 16' Boompole
Cable Kit for 16′ Mighty 6 section boompole (KP16). Requires a bottom module (KPCCR) to work. Top of cable features the New Mighty Boompole Right Angle Low Profile 3 pin connector. The Mighty 6 section boompoles have a removable headpiece therefore no soldering is required, simply drop the cable through the top section once the headpiece is removed, plug the TA3 into your bottom right angle exit module (KPCCR) and attach to the bottom of your KP16 boompole. Made in the USA, K-Tek’s Mighty Boompole cable has thicker gauge wire and stronger shielding than previous versions.
K-Tek has created a higher quality coiled cable featuring a brand new, low profile right angle connector. The new Mighty Boompole Cable incorporates thicker gauge wiring and aluminum shielding to make it both stronger and ultra-protected from radio frequency (RF) interference. The new Mighty Boompole Right Angle connector is smaller, lighter, serviceable, and made with the popular Neutrik connector as its base. A new solid strain relief makes the Right Angle connector remarkably robust while securely holding the wiring in place. As an added benefit, the connector orientation can be changed by simply unthreading its housing, rotating it to the desired position, and locking it back in place.
The TA3 at the base of the cable is surrounded by a machined Delrin shell which secures the cable to the connector. Simply plug the TA3 into the male end of the KPCCR module. In extreme weather conditions it may be wise to unplug and remove the cable from inside the pole. Keeping the bottom open by removing the bottom module or adding the flow through base (KPFT) will allow water to drain through the pole instead of filling the inside of the tubes. Made in the USA.
Compatability
- Cable Kit for the 16′ Mighty 6 section boompole (KP16).
- Requires a bottom module (KPCCR) to work.
Hire Equipment
We have an extensive inventory of audio equipment for hire with competitive rates ready at a moment's notice. We pay the most meticulous attention to detail in our hire prep so you can travel to shoots with the peace of mind that you have everything you need.
Weekly Rental
For weekly rental, you can pick up your gear the day before your production shoot after 3:00pm, and return by 10:00am after your shoot day. In the case of 7 day rental, you will only be charged for 4 billing days.
Shipping
If shipping is required, we require a two day minimum hire period, with a travel day inbetween.
Cancellations
Orders can be cancelled for free up to 24 hours before pick up date, any notice within 24 hours of the pick up date will be charged a prep fee of 25% of the total amount.
Insurance
Customers will provide a certificate of insurance listing Everything Audio as "loss payee" and "additional insured".